One amp was used for sub duty , the other I carefully used to
test input stages.
Both in the photo's have been tested and biased with 60V rails.
One amp (with the blue sharpie) , needs one 2SC3264. It
was biased and ran with it's existing 2 pairs.
The input stages are "Wolverines" , a "blameless" topology tested
at <10ppm 20K.
The extrusions are Heatsink USA 120 X 250mm. The amps stay <40C
even with heavy use.
I'm asking 100$ for all , buyer pays the shipping.
Thanks , Pete V. (OS)
test input stages.
Both in the photo's have been tested and biased with 60V rails.
One amp (with the blue sharpie) , needs one 2SC3264. It
was biased and ran with it's existing 2 pairs.
The input stages are "Wolverines" , a "blameless" topology tested
at <10ppm 20K.
The extrusions are Heatsink USA 120 X 250mm. The amps stay <40C
even with heavy use.
I'm asking 100$ for all , buyer pays the shipping.
Thanks , Pete V. (OS)
Attachments
Last edited:
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.