Looking for advice on midrange for a 3way - which would be better 2x4" in an MTM versus a single 6"?
(Am after sensitivity/dynamics/detail etc. all the usual audiophile terms)
(Am after sensitivity/dynamics/detail etc. all the usual audiophile terms)
Considerations-
Upper cutoff
Lower cutoff
midband sensitivity
Upper cutoff determined by driver circumference
Low cutoff determined by Vd
Two drivers doing same range when wavelengths become comparable to spacing- multidirectional system,not necessarily coherent.
http://www.woodartistry.com/linkwitzlab/x-sb80-3wy.htm
Upper cutoff
Lower cutoff
midband sensitivity
Upper cutoff determined by driver circumference
Low cutoff determined by Vd
Two drivers doing same range when wavelengths become comparable to spacing- multidirectional system,not necessarily coherent.
http://www.woodartistry.com/linkwitzlab/x-sb80-3wy.htm
An externally hosted image should be here but it was not working when we last tested it.
- Status
- Not open for further replies.