Unfortunately not. As I used to climb mountains for some reason I have been in almost every corner of the world that has mountains high enough. Greenland hasnt, but thats no reason not going there.
Replaced both ksa1381's/ 2sk117gr and Zener.
The ska1381's were replaced with these since I can't find fairchilds:
MJE350G - ON SEMICONDUCTOR - BIPOLAR TRANSISTOR, PNP, -300V | Newark
68k resistors OK? Voltage trimmer does something? Is there normal CCS mV indication on T.P. as before?
R10 shows 68k installed on the board - r9 shows 43.5k installed also, should I pull a leg up and retest? Or replace?
Voltage trimmer was replaced does minimal was tested before install and did work, can adjust mV's set to 393 what I need .19 + .20mA.
Now hold on just found a small amount of solder on q4 from outside leg to center cleaned it up and going to test
No change, do you think that it got shorted? Also I'm not familiar with how to test the 840 for vg's. Is it fairly simple? With the use of a volt meter?