Remove R10 so the on procedure will sync faster, just in case there is a rapid high charge.
I put a jumper instead R10?
Also there is some weird grey thing between your MJE transistor and a sink in your photos, what is that? Clean that area. MJE's back should not touch anything around it.
Removed and soldered a new one, see attached pic, it's OK?
Attachments
Last edited:
No continuity between any pin mosfet & screw, also no continuity between tab (mosfet hole) & screws, that's OK?
Scratch the sinks a little so you have some shiny scratch. Put the Ohm meter between metal tab of each Mosfet and its exposed sink's metal. Must read very high (open circuit).
Removed and soldered a new one, see attached pic, it's OK?
Looks much cleaner. From that angle seems it does not touch the sink although very near.
I see a hit 5k6 on the photo, is that working?
Yes it's R5 between MJE350 and GND.
- Home
- Amplifiers
- Power Supplies
- Simplistic MosFET HV Shunt Regs