front loaded 1segment horn, for 150hz 1000hz use.
loaded with b&c 12mh32 (i will use 4 of them).
Its my very first horn building so id like to understand howto not waste time,
these are the sims result:
loaded with b&c 12mh32 (i will use 4 of them).
Its my very first horn building so id like to understand howto not waste time,
these are the sims result:
An externally hosted image should be here but it was not working when we last tested it.
An externally hosted image should be here but it was not working when we last tested it.
An externally hosted image should be here but it was not working when we last tested it.
An externally hosted image should be here but it was not working when we last tested it.
An externally hosted image should be here but it was not working when we last tested it.
An externally hosted image should be here but it was not working when we last tested it.
It doesn't look like your simulation is accurately describing your design. You should use the air volume inside the 12" cone plus the air volume within the 2 baffle rings combined, as your Vtc.
Secondly, take in account (or better simulate) the increase in SPL, due to the directivity of the horn, both on-axis as well as off-axis.
Johan
Secondly, take in account (or better simulate) the increase in SPL, due to the directivity of the horn, both on-axis as well as off-axis.
Johan
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.