SF304A TO247 Dual diode cross

Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
Oh, then does it HAVE to be a dual diode in a TO247 then? How about a pair of TO220 single diodes? Mount them side by side - only takes slightly more room. Are you building or replacing?

Or get one of those square 30-35A bridge rectifiers and just use half of it. Bolt it to the chassis or the heat sink as needed. Even if this is a replacement of existing part, you can still mount a bridge on the chassis and run three wires back to the board.
 
Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.