Selector switch...selection

Status
Not open for further replies.
For a first project I would like to replicate a design like this:

RfEFrfC.jpg


Goal: switch 1 input between 4 outputs.

For the rotary switch, is it correct that I need a 2-pole, 4-position, non-shorting switch?

And, if you can recommend one, I would a appreciate that too!
 
You might consider switching using miniature relays; saves on complexity of the switch and the signal is not routed as for. There is a thread about this on DIYAudio. There are also designs which can be used as a template, if Googled.
 
Status
Not open for further replies.