Is it someone who can quality control my simulations here? 🙂
I use AJ Horn (newbie) but i assume Mathcad from M J King would do the same?
https://www.seas.no/index.php?optio...&id=532:h1794-08-fea18rcz&catid=53&Itemid=466
I use AJ Horn (newbie) but i assume Mathcad from M J King would do the same?
https://www.seas.no/index.php?optio...&id=532:h1794-08-fea18rcz&catid=53&Itemid=466
I haven't used any stuffing in HornResp in the 46 litre version (assuming my interpretation ok) so there is quite a bit of midrange resonances to be tamed. You could try comparing against similar/different volume tapered TL, sealed and bass reflex to see if anything is gained.
It needs stuffing. In my simulation i have filed the front with 40% i think.
I havent testet the driver yet but i must definitely have a baffelstep filter.
After what i can see from the specs it isnt the easyest driver to work with. I will try with impedance correction and notch filter aswell.
Here from Seas aplication note:
I havent testet the driver yet but i must definitely have a baffelstep filter.
After what i can see from the specs it isnt the easyest driver to work with. I will try with impedance correction and notch filter aswell.
Here from Seas aplication note:
I ended up trying out a bsc filter on my fullrange small TLs using one of the calculators-likely MJKs. I gave it about 3 months of trying different listening positions while the driver settled in before hand. It’s probably something I should re-evaluate now after 3 years to check if it’s still required.