So I have a fair amount of diy experience with repairing amplifiers and stereos and a strong electrical background.
My amplifier is stuck in protect. When I opened it up I could see that at least one of the large caps had vented or leaked (not sure which it did) so i went ahead and replaced both caps. The amp still wont come out of protect so I am guessing I have an issue that was caused by the caps, I was wondering if anybody with experience with these things has had the same issue or has any specific suggestion of components to look at.
I did notice there is a resistor that is burnt but it tested fine on impedance. My next plan is to open it back up, replace the burnt resistor, and check all the board paths near the caps for continuity.
Any help is appreciated!!!!
My amplifier is stuck in protect. When I opened it up I could see that at least one of the large caps had vented or leaked (not sure which it did) so i went ahead and replaced both caps. The amp still wont come out of protect so I am guessing I have an issue that was caused by the caps, I was wondering if anybody with experience with these things has had the same issue or has any specific suggestion of components to look at.
I did notice there is a resistor that is burnt but it tested fine on impedance. My next plan is to open it back up, replace the burnt resistor, and check all the board paths near the caps for continuity.
Any help is appreciated!!!!