Salvaged 1.8" LCD / Need to interface it.
Hi, I purchased a Kodak Personal Picture Printer, it has a 1.8" Color LCD (of undoubtedly low quality) for $5.
I also picked up a Honeywell Preview 600 Slide Projector for $5.
I'd like to interface the LCD from the Printer to either VGA or to NTSC. I'd like to know if this is possible, and where I can obtain information on this. The LCD is seperate from its driver board, so it will work in the projector. The driver board just has some ribbon cable on it. Is this a matter of wiring in a VGA connector into the the driver board?
Any suggestions, comments, or insights welcome!
Thanks
Hyperi0n
Hi, I purchased a Kodak Personal Picture Printer, it has a 1.8" Color LCD (of undoubtedly low quality) for $5.
I also picked up a Honeywell Preview 600 Slide Projector for $5.
I'd like to interface the LCD from the Printer to either VGA or to NTSC. I'd like to know if this is possible, and where I can obtain information on this. The LCD is seperate from its driver board, so it will work in the projector. The driver board just has some ribbon cable on it. Is this a matter of wiring in a VGA connector into the the driver board?
Any suggestions, comments, or insights welcome!
Thanks
Hyperi0n