One end of both these resistor connects to main ground and the others ends one connects to the first leg while the other connects to the center leg of D2061 transistor.
I change the resistor to 10 ohm and I replace the driver IC for the sub channel.Sub channel is playing good audio but I have nothing out of the other channels.I don’t see no drive going the the output ICs IRFI4122H.
I replace two bad 5v regulators but no change.It is using the same IRS2093M to drive the these channels.Any suggestions?
I replace two bad 5v regulators but no change.It is using the same IRS2093M to drive the these channels.Any suggestions?
Have you tried to get a diagram for this amp from Rockford? If not, contact tech support to try to get one.