Repairing a bd1500 and I need a MESHA board for the power supply and rectifier side. The MESHA board part number is QM-1778R-R. The board has some how become conductive so when you solder the fets to it the board has drain voltage on the bottom side and shorts it to the heat sink. I really dont want to have to build clamps and put tape down.
I know someone here has one could someone please help me out?
Thanks.
I know someone here has one could someone please help me out?
Thanks.
OK I will try them. The bigger punch amps like the 800 4 channel amps and such have the same MESHA boards as well. Just hoping someone has one.
I have a few 800 4 channel Rockford amps laying around good boards with no case but didnt want to sacrifice one.
I have a few 800 4 channel Rockford amps laying around good boards with no case but didnt want to sacrifice one.
Hmm, interested in selling an 800a4 board? If you have a pic of the mehsa board? Might have one that matches. There was a guy with tons of rf parts, but haven't heard from him in a while. Thread on this site, but need to email him...
- Status
- Not open for further replies.