Rockford 1000BD NO AUDIO PLEASE HELP

tpa954com

Member
2008-01-01 2:31 am
Hi i have a rockford bd 1000 it has no AUDIO AT ALL i connect everything and everything seems fine right when i connect the remote wire i goes directly into protect mode . There is nothing melted or burnt inside the amp and i cant really figure out what is wrong any one have any ideas, Thanks for the help.

Robert
 
Normally, the protect light comes on initially and then goes out after a couple of seconds. Is your amp staying in protect for longer?

If so, is there any DC voltage across the speaker terminals?

What is the DC voltage across the red and black twisted wires?

Be careful when placing your probes. There is high voltage across the wires when the power supply is operating. Do not let the probes short between pads or to any of the jumper wires.