How much is a lot? You need to be specific. Try to think ahead and provide as much information as possible.
Is the amp producing both positive and negative rail voltage?
If you operate all of the controls through their entire range, how does it affect the noise?
If it makes a difference, which control(s) make the most difference?
Is the amp producing both positive and negative rail voltage?
If you operate all of the controls through their entire range, how does it affect the noise?
If it makes a difference, which control(s) make the most difference?
the amp is producing both positive and negative rail voltage.
no control affect the noise but the gain.
the amp pulled 5amps. then went over 10amps. my meter stops at ten.
the output transistor q209.q208q207.q210 got very hot.
the two output drive transistors q205.q216 reads 100 ohms. across the 1and3 legs.
im going to pull q209.q208q207.q210.
no control affect the noise but the gain.
the amp pulled 5amps. then went over 10amps. my meter stops at ten.
the output transistor q209.q208q207.q210 got very hot.
the two output drive transistors q205.q216 reads 100 ohms. across the 1and3 legs.
im going to pull q209.q208q207.q210.
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- General Interest
- Car Audio
- rf t1000