You cheated! That's doublesided 🙂
But you ended up with the same size as me in fact - just divided into four boards.
Best regards,
Mikkel C. Simonsen
But you ended up with the same size as me in fact - just divided into four boards.
Best regards,
Mikkel C. Simonsen
This is the initial drawing of the digital board, I guess this is pretty much standard.
First I opted for a PIC controller, but changed to Atmel after a tip from mcs 🙂
Still need to check the values for the resistors on both sides of the optocouplers 🙂
And there is no IR receiver connected, because I couldn't find the correct drawing for the component.
First I opted for a PIC controller, but changed to Atmel after a tip from mcs 🙂
Still need to check the values for the resistors on both sides of the optocouplers 🙂
And there is no IR receiver connected, because I couldn't find the correct drawing for the component.
An externally hosted image should be here but it was not working when we last tested it.
- Status
- Not open for further replies.