Good day everyone, hope y’all are well
What are your guys’ best practices or suggestions for rear mounting drivers to a baffle?
I’m specifically having a bit of a hard time trying to read mount an SB17NBAC to the rear of my baffle, as I’ve noticed the driver frame has a bit of a curved lip to it (as opposed to being a totally flat frame) - would anybody have any tips for this scenario?
Thank you guys in advance
What are your guys’ best practices or suggestions for rear mounting drivers to a baffle?
I’m specifically having a bit of a hard time trying to read mount an SB17NBAC to the rear of my baffle, as I’ve noticed the driver frame has a bit of a curved lip to it (as opposed to being a totally flat frame) - would anybody have any tips for this scenario?
Thank you guys in advance
Greets!
From just pictures, not sure what you're referring to unless it's the 'beauty' ring's lip, but doesn't it just pop off for rear baffle mounting?
From just pictures, not sure what you're referring to unless it's the 'beauty' ring's lip, but doesn't it just pop off for rear baffle mounting?
Hopefully the photos attached help illustrate what I’m saying - not too certain whether or not it’s a beauty ring, but I’ll give it a shot?
I’ve tried using nut inserts to mount them from the rear as well, but the frame lip I mentioned above seems to be giving me a little bit of a headache so far - hence this thread
I’ve tried using nut inserts to mount them from the rear as well, but the frame lip I mentioned above seems to be giving me a little bit of a headache so far - hence this thread
