Hi,
i'm ready to get these puppies tip top
where should i start?
and then, where should i end?
another words:
how can i make these the best they can be!? 😀
i'm ready to get these puppies tip top
where should i start?
and then, where should i end?
another words:
how can i make these the best they can be!? 😀
nothings wrong, i just know there's people who have modded it to sound much much better and i don't even know where to start!
There was an article published sometime ago (can't remember where----"senior moment") that recommended replacing the coupling caps, I believe the author used Auricaps, and was impressed with the result. These are single tube (6Bm8) if I recall correctly.
Regards
Pete
Regards
Pete
Ok, some general suggestions in $$$ order for your amp:
1) Nichicon Muse or Elna Cerafine cathode bypass capacitorss on preamp/ power amp tubes.
2) Ultrafast power supply diodes and better power supply caps.
3) Inductors in the power supply (say 5-10H 80mA) between first and second cap ( remove the resistor)
4) better output transformers
ECL82 is a nice sounding valve. 😉
1) Nichicon Muse or Elna Cerafine cathode bypass capacitorss on preamp/ power amp tubes.
2) Ultrafast power supply diodes and better power supply caps.
3) Inductors in the power supply (say 5-10H 80mA) between first and second cap ( remove the resistor)
4) better output transformers
ECL82 is a nice sounding valve. 😉
- Status
- Not open for further replies.