I got a pair of 32 Ohm Outputs for a headphone amp. One of them had a wiring error. I had to take it apart and connect the correct wire to the correct terminal.
I got the whole thing built and one channel worked and the other didn't It took a bit but finally I took both transformers out and compared the wires and sure enough the one that didn't work was different.
I will say they sound excellent and at 180.00 for a pair of potted outputs is pretty reasonable.
I got the whole thing built and one channel worked and the other didn't It took a bit but finally I took both transformers out and compared the wires and sure enough the one that didn't work was different.
I will say they sound excellent and at 180.00 for a pair of potted outputs is pretty reasonable.
Best Low cost iron for tube amps by far is EDCOR.
They use M6 laminations, hand stacked on outputs, power transformer and chokes.
Outputs start at $18 and they are good.
They use M6 laminations, hand stacked on outputs, power transformer and chokes.
Outputs start at $18 and they are good.
- Status
- Not open for further replies.