Are you saying this?:
The amp is very quiet, and there is no output unless you hit the strings very hard.
The amp is very quiet, and there is no output unless you hit the strings very hard.
Hi Scott,
I was saying two things, the hum/noise had gone almost entirely after re routing the grounding. there is more I could do but I will leave that for the next attempt. the other problem was actually caused by a bad solder point in a speaker cable. So it was easily overcome. Thank-you for your reply though, I appreciate all the help I have been getting from everyone. There is so much to learn!
Regards
Luke
I was saying two things, the hum/noise had gone almost entirely after re routing the grounding. there is more I could do but I will leave that for the next attempt. the other problem was actually caused by a bad solder point in a speaker cable. So it was easily overcome. Thank-you for your reply though, I appreciate all the help I have been getting from everyone. There is so much to learn!
Regards
Luke
- Status
- Not open for further replies.