OK When I read through the forums I found a thread that stated when It comes to Power supplies, Black Is ground, White -5,
yellow +12, and red is +5, However on one of My power supplies it dosent say anything, It shows some specs but dosent list what colors, so am I to assume its still the same. I have attacted a pic of it . Thanks for any further help. Oh also the wires I dont Use what should I do with em, take the PS cover off and clip them where they touch the curcuit board( basically I want to keep the rats nest to a minimum) thanks for any further insight.
OOps forgot, They both have the origonal puch button switches, can I just take the PS apart and drill a hole and mount the switch on the ps? and then just take the extra length of wire and stuf it inside the ps?
yellow +12, and red is +5, However on one of My power supplies it dosent say anything, It shows some specs but dosent list what colors, so am I to assume its still the same. I have attacted a pic of it . Thanks for any further help. Oh also the wires I dont Use what should I do with em, take the PS cover off and clip them where they touch the curcuit board( basically I want to keep the rats nest to a minimum) thanks for any further insight.
OOps forgot, They both have the origonal puch button switches, can I just take the PS apart and drill a hole and mount the switch on the ps? and then just take the extra length of wire and stuf it inside the ps?
Attachments
- Status
- Not open for further replies.