Or maybe the Shunter is X-rated material in Scandica ?
(he should start thinking about buying wholesale at Nuvotem)
Psst=>
(he should start thinking about buying wholesale at Nuvotem)
Psst=>
Manu said:
sorry - not yet pottery lottery ......
Igor haven't time for short trip to HU
tuesday , probably
jacco vermeulen said:
Yes wattsdat?
H-sink? Why ?
manu
BTW : good idea to abuse manufactured chassis... I want to see the frontplate.
Manu said:
me thinks that crazy (most crazy! ) danske will tell us , when he rise his ..... nice
head here
Manu said:
btw - how can I be disappointed ?
this thread obviously make ya nutz completely ........
😀
Zen Mod said:
I thought you got pot (hehe) and you're mebbe disappointed, but, as tactful boy we know you are, didn't say nothing...
This thread (le dernier salon où l'on cause 🙂 ) cannot make me nutz because I am already.
(It could have fullfilled my nutzity, though)
jacco vermeulen said:
Looks like some extra heatsink, bolted to a too small heatsink.
Could be wrong, though😉
🙂
Zen Mod said:
me thinks that crazy (most crazy! ) danske will tell us , when he rise his ..... nice
It's not the faceplate that's of interest, but the rear that differs from standard 😉 Ever seen a box with more redundant holes?
Magura 🙂
Manu said:
The gallery has gone south, so even if you had the link, it would not be any good.
I am currently as the stage of buying a domain, then the need of somebody whom can and will make a webpage will be the next obstacle.
Magura 🙂
hershann said:
Ahh, you like the rubber suspensions 🙂 The trafo is pulled out of an old Yamaha C50 preamp. It is 36-0-36V. The Yamaha C70 had the same trafo. I just found one more🙂 You can probably find a defective C50/C70 preamp for cheapo somewhere near you.
Magura said:
It's not the faceplate that's of interest, but the rear that differs from standard 😉 Ever seen a box with more redundant holes?
Magura 🙂
Looks like someone build and tested a lot of preamps in that case.
Now who would ever do a thing like that, to such a nice case
😕
🙂
steenoe said:
Anything needed to be changed on Shunty if I use a 36v-0-36v transformer? Found a 72VCT 50VA transformer that is much smaller than the 250VA 84VCT I found earlier - but I guess 50VA might be too anemic.
I do not need that much gain planning on 5 or 7 - so a lower max voltage swing does not matter.
Still looking for suggestions for good source of EI transformers - only sinker is that I am going to need 240V primary.
her shann