I know this probably isn't an easy one, two question to answer but....can anybody give me a fairly straight forward approach to calcuating the "load" resistance you use to run the calculations. For instance, I am buiding a fairly simple preamp using a single 5687 tube and I wanted to use this program to design a PSU....but I would't know the load resiator value to inpt into the program. I iagine if I am using 2 sides foe stereo then part of the value will be 1/2 the plate resistance at my voltage, but what about any other resistances in the circuit....do you just add them up? Th 5687 tube has a plate resistance of about 3000 at 250v as I recall, so two of these in parallel would be a resistance of 1500. WHAT ABOUT THE PLATE RESISTORS TOO? DO YOU JUST ADD THOSE IN TOO? these are 10k, so would it be the same...add 1/2 of this to the 1500 which equals 7500. Is there any thing else I am missing.
Thanks,
Jeff
Thanks,
Jeff
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.