poobah said:And why is that?
Good question....
I changed the Values of C1 from 100uf to 40uf R1 from 110 to 1.25K and C2 from 200uf to 80uf
The original tranny was 190-0-190
Here's the PSUD File: http://www.bytesunlimited.us/SS.psu
Using the 5U4GB dropped the voltage too low
So I found a 235-0-235 tranny with 6.3 and 5 V taps
Here's the crc version http://www.bytesunlimited.us/Tubecrc.psu
The voltage is way to high with the original values except for C1 changed to 40uf
I made a rcrc filter here http://www.bytesunlimited.us/Tubercrc.psu
The voltage now seems more in spec. Is this good?
Here's the PSUD File: http://www.bytesunlimited.us/SS.psu
Using the 5U4GB dropped the voltage too low
So I found a 235-0-235 tranny with 6.3 and 5 V taps
Here's the crc version http://www.bytesunlimited.us/Tubecrc.psu
The voltage is way to high with the original values except for C1 changed to 40uf
I made a rcrc filter here http://www.bytesunlimited.us/Tubercrc.psu
The voltage now seems more in spec. Is this good?
poobah said:Cost...
Ahhhh... I passed that threshold many moons ago. While I usually don't go for blackgates, I don't mind spending a few bucks on an extra cap and resistor
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- Amplifiers
- Tubes / Valves
- PSU question? Going tube rectified