Proper headers for this card

[Deadly Sones]

Good morning

Just wondering if anyone happens to have a link to Digikey or Mouser for the proper headers for these cards? Or maybe somewhere else?

Thanks in advance!

 

[Deadly Sones]

Need so I can plug card in and out without soldering over and over. 🙂

 

[Deadly Sones]

Bump. All the headers I find, seem to have pins too large for the board. Spacing and stuff no problem.

 

[levistubby]

Telling us the pitch of the pins would help us to help you.

 

[ximikas]

Hi , for me it looks like standard 2,54mm pitch . But making it as a connector is a risky thing blow something ,if at least one pin have bad contact. Maybe better idea would be look for jst 2,54mm pitch connectors , they can be many variants of pin counts, solder solid wires from female connector to this card, or even solder female contacts on these pins from this card ,and solder male part to motherboard. Just my few cents.

 

[Deadly Sones]

When I measured across 11 I averaged right about 2.50mm... 2.54 could be right.

 

[ximikas]

Should match vero board holes too ,if you have handy.

 

[Perry Babin]

The original pitch was likely 0.1" which is 2.54mm. The only other spacing I've seen on this type of amp is the 2mm.