HI folks. wasnt too sure where to post this so here goes
I have a brand spankin new lamp that I have no use for at all. It is an original not a china copy or anything like that. I used to work for a reseller here in my town and scored this lamp but i can't use it so. Its part number 610 323 0726 / 610 332 3855 / LMP90 / LMP106 and i got it for a sanyo plc-xu73 but i know it fits other models. its a 200w UHP. If you want it make me an offer or a trade. Mainly im interested in someone helping me technically. If you can give me a definite answer to my problem the lamp is yours for FREE! I have an EP721 im looking to relamp on the cheap. I tested it w/ a 35w 12v MR16 and worked fine but for a short time of a week. The socket used is a 4Amp 25v 100w GU 5.3, but a 50w MR16 would not strike properly, just comes on dim and then goes out and projector says bad bulb, but the 35w always works. My lamp housing says it uses a Phoenix SHP 112 180w. what is the 112? is that the voltage? Im pretty sure it uses DC lamps as to why the mr16 worked but not sure why the 50w doesnt. So the question is, in order to get to work, i found some MR16 sockets rated up to 250v 300w. Do you think this socket and a 150-200w 21v MR16 lamp would get me an inexpensive solution? If you can figure this out and it works just gimme an address and ill send the complete lamp module i'm offering. If not, then make me an offer for $$$ or something you want to trade. And no im not looking for close to retail pricing on this thing, im open to best offer. Pictures I can send if you're interested....... thanx
I have a brand spankin new lamp that I have no use for at all. It is an original not a china copy or anything like that. I used to work for a reseller here in my town and scored this lamp but i can't use it so. Its part number 610 323 0726 / 610 332 3855 / LMP90 / LMP106 and i got it for a sanyo plc-xu73 but i know it fits other models. its a 200w UHP. If you want it make me an offer or a trade. Mainly im interested in someone helping me technically. If you can give me a definite answer to my problem the lamp is yours for FREE! I have an EP721 im looking to relamp on the cheap. I tested it w/ a 35w 12v MR16 and worked fine but for a short time of a week. The socket used is a 4Amp 25v 100w GU 5.3, but a 50w MR16 would not strike properly, just comes on dim and then goes out and projector says bad bulb, but the 35w always works. My lamp housing says it uses a Phoenix SHP 112 180w. what is the 112? is that the voltage? Im pretty sure it uses DC lamps as to why the mr16 worked but not sure why the 50w doesnt. So the question is, in order to get to work, i found some MR16 sockets rated up to 250v 300w. Do you think this socket and a 150-200w 21v MR16 lamp would get me an inexpensive solution? If you can figure this out and it works just gimme an address and ill send the complete lamp module i'm offering. If not, then make me an offer for $$$ or something you want to trade. And no im not looking for close to retail pricing on this thing, im open to best offer. Pictures I can send if you're interested....... thanx
- Status
- Not open for further replies.