On My ' Harman Kardon AVR 20 Dolby Pro Logic Suround 5.1 AV
Receiver '.
There Is Not Any Sound Playing Out Of The Suround Sound's Right &
Left Rear Speaker's. But When I Press The 'TEST' Button The Tone Is
Heard Just Fine Through The Left & Right Front Speaker's & Also The
Center Chanel Speaker, But The Rear Suround Sound Speaker'sPlay's
The Test Tone At A Very Low Volume.
The User's Manual Say's On The Original Remote Control ( Which I
Don't Have ) You Can Adjust The Rear Speaker's Volume With The
Remote Control. Is This The Only Way The Rear Suround Sound
Speaker's Can Be Adjusted.
Receiver '.
There Is Not Any Sound Playing Out Of The Suround Sound's Right &
Left Rear Speaker's. But When I Press The 'TEST' Button The Tone Is
Heard Just Fine Through The Left & Right Front Speaker's & Also The
Center Chanel Speaker, But The Rear Suround Sound Speaker'sPlay's
The Test Tone At A Very Low Volume.
The User's Manual Say's On The Original Remote Control ( Which I
Don't Have ) You Can Adjust The Rear Speaker's Volume With The
Remote Control. Is This The Only Way The Rear Suround Sound
Speaker's Can Be Adjusted.
Welcome to the forum. This will be move to the Solid State section.If you have a HK remote control even if its not the original HK says try a reset on it.
1-remove batteries.
2-hold down all the buttons.
3-short out both plus+ minus of the battery holder .
If I have picked you up wrong and you don't have a HK remote then that might not work.
Looking at the instruction manual and the front PANEL controls =
to drive both pairs of speakers push both 1&2 switches IN.
Also has the surround mode selector switch been pressed ---once
?
There is also different surround modes the rear speakers in surround mode only reproduce the surround signals .
The actual panel controls are able to achieve a lot of functions depending on how you operate them according to the manual without the remote.
1-remove batteries.
2-hold down all the buttons.
3-short out both plus+ minus of the battery holder .
If I have picked you up wrong and you don't have a HK remote then that might not work.
Looking at the instruction manual and the front PANEL controls =
to drive both pairs of speakers push both 1&2 switches IN.
Also has the surround mode selector switch been pressed ---once
?
There is also different surround modes the rear speakers in surround mode only reproduce the surround signals .
The actual panel controls are able to achieve a lot of functions depending on how you operate them according to the manual without the remote.