I have a DigiMod 1000 and a Digimod 500. iIs there a design manual? I am wondering how to easily fit a volume control but Powersoft do not reply to my emails.
Did youi have a look at https://www.powersoft.com/wp-content/uploads/2019/01/powersoft_DM1000_quickguide_v2.0.pdf ?
Regards
Charles
Regards
Charles
In order to connect the master module outputs to the slave module inputs:
1. Connect the cable that you’ve just made to the DSP in the DigiMod 1000NPS master module (with the MOLEX 3-pin connector).
2. Connect the other end of the cable with its two Phoenix 5-pin connectors to the slave module’s input connectors
1. Connect the cable that you’ve just made to the DSP in the DigiMod 1000NPS master module (with the MOLEX 3-pin connector).
2. Connect the other end of the cable with its two Phoenix 5-pin connectors to the slave module’s input connectors
I've been searching for a Powersoft digimod 1000 for a while now with no luck. Did you manage to get any use out of yours ?