one of these with a 600VA trafo might do you:
http://connexelectronic.com/product...ducts_id/54?osCsid=v05kujhklab1147bnpktbev7l7
use their power supply too.
Iv'e just built one of these, it sounds great.
there is some more info in these forums just search TA3020
col.
http://connexelectronic.com/product...ducts_id/54?osCsid=v05kujhklab1147bnpktbev7l7
use their power supply too.
Iv'e just built one of these, it sounds great.
there is some more info in these forums just search TA3020
col.
Call me, 514-835-3846, I speak french too. I will show you room and give you some advise and direction to make your 500W amp...But just be prepared to put what you need and dont cut corner. I hate people that do thing cheapest as possible. And I will not sell you anything, but give you direction where to find right parts. My biggest amp was a 10 KW RMS into 4 ohms...
Fredos
Fredos
Yep I would say SBS is a little overdoing it on marketing terms, what :bs: 
He says its the best rated sound in clubs and by audiophiles, clearly he doesnt even know what audiophile means, I bet those arent lm3886 chipamps anyway.
I see one very good suggestion here though, its by CJ900RR, now a amp around this with high power is very good, I tried one, comes much closer to a audiophile amp and abuse is no problem, design the output stage well. There are another 2 chips in the same range which could be better as they have higher output to drive a outputstage, all depends on the outputstage design. Also take a look at fotios amp in solidstate threads, thats most probably better souding than most pro gear, and built like a tank for this type of application.
He says its the best rated sound in clubs and by audiophiles, clearly he doesnt even know what audiophile means, I bet those arent lm3886 chipamps anyway. I see one very good suggestion here though, its by CJ900RR, now a amp around this with high power is very good, I tried one, comes much closer to a audiophile amp and abuse is no problem, design the output stage well. There are another 2 chips in the same range which could be better as they have higher output to drive a outputstage, all depends on the outputstage design. Also take a look at fotios amp in solidstate threads, thats most probably better souding than most pro gear, and built like a tank for this type of application.
infectdrhythms said:
Who needs 500W Stereo in a DJ booth 😕 Better you think about some sealing instead of a huge diy power amp ... If you need so much power only for monitoring, something else is wrong. Just my two cents.
regards
- Status
- Not open for further replies.