No one is yet licensed to build any of my designs, but for a run of a few boxes it's no problem. There are lots of guys out there building my stuff for their own use, and I'm sure some of them would be willing to build you an AutoTuba, or at the least help you do so. It is one of the easier of my designs to build. I'd put a post on my forum at
http://www.audioroundtable.com/BillFitzmaurice/
to find someone in your area willing to help you out.
http://www.audioroundtable.com/BillFitzmaurice/
to find someone in your area willing to help you out.
Thanks Bill, I'll do that.
Jim, this won't be for public use most likely, it's mostly for near field listening. I really like horn loaded subs, but this is the first of it's size I've seen. It would be to replace a direct radiating, run of the mill sub cube that I built when I did have access to a table saw. I get decent performace out of it, it just has some funny spots due to the box tuning. My monitors do down to 50hz, so it's just to fill in the bottom end.
Jim, this won't be for public use most likely, it's mostly for near field listening. I really like horn loaded subs, but this is the first of it's size I've seen. It would be to replace a direct radiating, run of the mill sub cube that I built when I did have access to a table saw. I get decent performace out of it, it just has some funny spots due to the box tuning. My monitors do down to 50hz, so it's just to fill in the bottom end.
- Status
- Not open for further replies.