yes you have me down for two i think. I really just want the psu pcb's to make this a litlle easier i just know enough about this to be dangerous.😀 and i really like the idea of some instructions
thanks
thanks
Aah...if only it was so easy 😀
I will have to stick to my dayjob for quite a while still..so this is really a labour of love
Bas Horneman said:
Let's make it two of each, might as well make it as easy as possible.
SteveA
SteveA and veg1515 and everyone else....you only need 1 psu pcb per 2 channels...unless you want to go fully dual mono.
Bas Horneman said:
BAS-
Just to clarify, I would like two of the Aikido pcb's and two of the Aikido PSU pcbs.
Thanks
SteveA
Member
Joined 2002
Aikido pcb
BAS-
You have me listed for 2 PSU boards (which is correct). I would also like 2 of the linestage boards as well.
Thanks,
SteveA
BAS-
You have me listed for 2 PSU boards (which is correct). I would also like 2 of the linestage boards as well.
Thanks,
SteveA
2 psu!
Woooaahh. You guys have been busy. Didn't know that the PSU would be that involved. Count me out. Just kidding!
I'll take 2 PSU boards in addition to the 2 main boards I already ordered.
Hey, thanks for doing up a manual. Looks like this will be a very good project for the tube beginner. Where do I get the rubber gloves?
Woooaahh. You guys have been busy. Didn't know that the PSU would be that involved. Count me out. Just kidding!
I'll take 2 PSU boards in addition to the 2 main boards I already ordered.
Hey, thanks for doing up a manual. Looks like this will be a very good project for the tube beginner. Where do I get the rubber gloves?