I'm in the process of assembling my UcD180 stereo-amplifier.
These are the items I have:
1 x Hypex UcD supply ST
2 x UcD180
2 x TR100A 160VA transformer
wires, connectors etc.
I don't have alot of experience though, so I have a question:
http://www.hypex.nl/docs/TR100A.pdf
Can I use the 2 transformers in parallel/series? It has 2 pairs of primary windings of 115V (my mains is 230V), and details how to use one transformer to accept 230V, by connecting the white and the blue wire.
So can I connect the white wire on one of them with the blue wire on the other one? And if I can, how do I get the output, should I just put them in parallel at the output, and then get double capacity?
This would mean I'd take a red wire from each transformer and attach to J9 on the diagram and so on?
These are the items I have:
1 x Hypex UcD supply ST
2 x UcD180
2 x TR100A 160VA transformer
wires, connectors etc.
I don't have alot of experience though, so I have a question:
http://www.hypex.nl/docs/TR100A.pdf
Can I use the 2 transformers in parallel/series? It has 2 pairs of primary windings of 115V (my mains is 230V), and details how to use one transformer to accept 230V, by connecting the white and the blue wire.
So can I connect the white wire on one of them with the blue wire on the other one? And if I can, how do I get the output, should I just put them in parallel at the output, and then get double capacity?
This would mean I'd take a red wire from each transformer and attach to J9 on the diagram and so on?