Hi all,
With about 5 hours on my minimal IGC, things are sounding great. I'm impressed.
I'm getting 15mv and 22mv DC offset with a wire between Pin 7 and ground. I wanted to experiment with a resistor from Pin 7 to ground.
Should I use EXACTLY the same value as my feedback resistor (237k) or can I get by for now experimenting with whats in the drawer (220k).
I assume you would want a close match ultimately.
Thanks again,
Steve
With about 5 hours on my minimal IGC, things are sounding great. I'm impressed.
I'm getting 15mv and 22mv DC offset with a wire between Pin 7 and ground. I wanted to experiment with a resistor from Pin 7 to ground.
Should I use EXACTLY the same value as my feedback resistor (237k) or can I get by for now experimenting with whats in the drawer (220k).
I assume you would want a close match ultimately.
Thanks again,
Steve
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- Amplifiers
- Chip Amps
- Pin 7 to ground question for IGC