I got my mids and tweets in today, I'll post pics of the finished assembly (well sort of, I'll explain) as well as the tweets and mids I pulled out.
The reason I say sort of is because the tweets don't quite fit the bore, the screws are too close to the edge, so I have pinned them down from the outer edges for now, but I need another solution. I was thinking about making new baffle boards (something that is close to the tone of the outer walls of the cab) and cutting new bores for the components. That would start driving my cost up some (not much but some) so I am also thinking about just making a spacer place just for the tweeter.
The numbers I pulled off the original tweeters are...
2422 257 33102
AD 0160/T8
I am also considering sanding and painting the existing baffle boards black (as well as the rear baffle.
I still don't know what the ultimate fate of these drivers and cabs will be. Somebody help me make a decision...
The mids look interesting too (I'm about to go look them up), but not nearly as interesting at the rest...
The reason I say sort of is because the tweets don't quite fit the bore, the screws are too close to the edge, so I have pinned them down from the outer edges for now, but I need another solution. I was thinking about making new baffle boards (something that is close to the tone of the outer walls of the cab) and cutting new bores for the components. That would start driving my cost up some (not much but some) so I am also thinking about just making a spacer place just for the tweeter.
The numbers I pulled off the original tweeters are...
2422 257 33102
AD 0160/T8
I am also considering sanding and painting the existing baffle boards black (as well as the rear baffle.
I still don't know what the ultimate fate of these drivers and cabs will be. Somebody help me make a decision...
The mids look interesting too (I'm about to go look them up), but not nearly as interesting at the rest...