peavey 260C schematic?

Status
Not open for further replies.
Jump to Latest
S

Stantonmaster

Member
Joined 2008
#1
Hello Has anyone got a Schematic for a peavey 260C Amplifer module. I have a bass combo mark 3 in for repair. The driver and output stage has failed and also the speaker.. There are some burned off resistors on the board connected to the the driver stage transistors which are a 5331 and a 5332.I have found the eq for the transistors MJE243,MJE253 and MJ15003 for the ouput but the two resistors which are connected to the driver transistorshave burned and I cannot read them. Can someone help??????Many thanks
 
#4
I have contacted peavey but they keep sending me the wrong schematic. They seem to think the bass combo mark 3 has a 300 amp module and sliders as controls but the one I have has control knobs and a 260C amp module. I have serched this forum and found the replacement part numbers as peavey use in house numbers but I need to know the value of the burned resistors.....
 
#5
Have been looking round the site and found out that they may be 47R resistors but peavey have sent me the 300 schematic AGAIN. The resistors seem to be to the collecter of one of the drivers and the emmitter of the other driver. Please can anyone shed any light on the subject????????????
 
Status
Not open for further replies.
Top Bottom