PCM1701 datasheet ?

[Bernhard]

Hi,

I have DCD1560 with 2 x PCM1701 K3 ( K3 😕 ) and look for datasheet....

 

[jean-paul]

You could try by asking politely if somebody has it for you.....

 

[Bernhard]

Please somebody have the datasheet for me ?

 

[PTSOUNDLAB]

Hello,

I would like to replace the opa I/V conversion on my DP8020 by a passive I/V with resistor.
My idea is to do like that

An externally hosted image should be here but it was not working when we last tested it.

But I have a doubt about Ref DC and BPO DC
Does I let Ref DC connected to -Vcc and BPO DC to Ground via capacitor ?

Thank you in advance for any help

Regards

Pascal

 

[PTSOUNDLAB]

Hello,

I tested this on my Kenwood DP-8020. After the 220 ohms resistor I have a generic anode follower stage with 5703W tubes. The sound is very very good.

We need just to isolate the pin 13, put a resitror between this pin and ground and insert the 5703W stage.

Regards

Pascal