As seen in this thread. These are the best ones John (Patrick Bateman) printed. I bought them off him and as seen in the thread, sanded smooth, painted & top-coated them. They are roughly 8.5”W x 6.5”H x 3.25”D.
The Gento midrange drivers are included (eight in total); all that’s still required is tweeters for the pair: SB19ST
These could be used towards a great, one-of-a-kind active monitor setup using DSP.
I paid $199 for the pair and that is what I would like to sell them for. Buyer covers shipping. CONUS only.
The Gento midrange drivers are included (eight in total); all that’s still required is tweeters for the pair: SB19ST
These could be used towards a great, one-of-a-kind active monitor setup using DSP.
I paid $199 for the pair and that is what I would like to sell them for. Buyer covers shipping. CONUS only.
Attachments
Last edited:
Hello Brinkman, I’m writing you from Italy and I‘m very sorry to pollute your thread, but I can’t find any other way to contact you. I’ve searched for a “contact member” form but didn’t find it.
Perhaps it doesn’t appear to me because I have zero posts as of now, or for some reason I don’t know. I’d like to ask you some information about an old project and discuss some ideas.
Could you kindly send me a message, if this is allowed to you, to which I can (hopefully) reply?
Thank you and sorry again for not being on topic.
Regards,
Giorgio
Perhaps it doesn’t appear to me because I have zero posts as of now, or for some reason I don’t know. I’d like to ask you some information about an old project and discuss some ideas.
Could you kindly send me a message, if this is allowed to you, to which I can (hopefully) reply?
Thank you and sorry again for not being on topic.
Regards,
Giorgio
I’ll selling these because I’m trying to thin the herd in anticipation of a move. Ideally, I will have as little to move as is possible and only drivers/devices intended for projects with a beaten path will make the cut. So really, open to any offers.
