Pass X350 voltage & current

[ANADIGIT]

Hi,
I had got Pass X350 from USA but it can't use in 220VAC.
How do I change primary voltage and current with a new transformer ?

I decide to order Amplimo Transformer but I can't see any voltage and current information of power transformer.

regard
Anadigit

 

[BobEllis]

http://www.diyaudio.com/forums/pass-labs/121653-x350-5-a.html probably close enough for sourcing a step down transformer, but I bet that you can rearrange the wiring internally to run your amp on 220.

 

[Nelson Pass]

The voltage is are 76 volts c.t. at 16 amps, which produces
+/-57 volt rails.

😎

 

[ANADIGIT]

Yeah !

So many thanks PAPA.

Your ampliifer drive my speaker more powerfull.

Thanks
Anadigit

 

[HiFi Si]

Without sounding too ignorant, but isnt there quite a bit more to this than just changing the transformer?

I looked at buying one from Reno a few years ago, but received the advice that the led in the front also plays a role and there is quite a lot more to change and get the biasing right, etc?

I gave up and purchased a new X350.5 and XP10. Love them!

 

[Nelson Pass]

No, it pretty much comes down to having the right transformer
taps and changing the fuse/breaker value.

😎

 

[motionpicture007]

Pass Labs X350 voltage change

I have a late model Pass X350 with a single voltage transformer. I am selling it to a buyer over seas and he wants to know if the voltage can be changed to run on 220v. (Asia) Can this be done at Pass Labs or am I stuck? Any help would be great regarding this.

 

[tinitus]

motionpicture, your question is a commercial affair, and not diy
you have to contact PassLab directly

 

[motionpicture007]

Pass Labs X350 voltage change

Thank you, I figured that would be the case as he wants Pass to do the work.

 

[Nelson Pass]

I have a late model Pass X350 with a single voltage transformer.

I am not aware that there are X350's with only the single
voltage transformer.

😎