Hi Hikari , water is pure water and i change it often ,usually when its conductivity get lower than 100 kohms/cm , drains are 200 cm away from each other .
I have no failsafes , when the fan failed i found the water temp at 75 ° , ( room temp was 25 ° and radiator was dirty !! ) but the amp was working "good" , this is strong stuff !!!
I thing I will keep the bias at 1.3 A , for now .
.
I have no failsafes , when the fan failed i found the water temp at 75 ° , ( room temp was 25 ° and radiator was dirty !! ) but the amp was working "good" , this is strong stuff !!!
I thing I will keep the bias at 1.3 A , for now .
.
😀 YOUR opinion. More than 1.4 proved to be of no advantage on My setup ...and My heatsinks are Overkill.
Last edited:
- Status
- Not open for further replies.