There has always been a lot of disscussion on the best way to layout a printed circuit board when digital signals are near low level audio signals. I would like to point every one to an arcticle on this from a person that I consider to be expert on the subject. I certainly follow his advice.
If you are interested in reading this article follow this link:
http://www.planetanalog.com/printableArticle?doc_id=OEG20010711S0054
Best regards to all,
John Fassotte
Alaskan Audio
If you are interested in reading this article follow this link:
http://www.planetanalog.com/printableArticle?doc_id=OEG20010711S0054
Best regards to all,
John Fassotte
Alaskan Audio
Hmm, fair call. For an alternative perspective try http://www.analog.com/support/standard_linear/seminar_material/highspeed/7b.pdf
As I recall there was a lot of good stuff in this seminar material.
Cheers,
Pete
As I recall there was a lot of good stuff in this seminar material.
Cheers,
Pete
- Status
- Not open for further replies.