Hi folks!
I´d like to run the P3A with about 45-50V rails. Anyone tried this? What changes to be made? How many pairs of output-transistors to use (on 4 Ohm load)?
By just looking on the schematics I think it should work without changes, except for using at least 2 pairs of output-transistors (MJL21193/94) - but I might be wrong?!
Regards!
I´d like to run the P3A with about 45-50V rails. Anyone tried this? What changes to be made? How many pairs of output-transistors to use (on 4 Ohm load)?
By just looking on the schematics I think it should work without changes, except for using at least 2 pairs of output-transistors (MJL21193/94) - but I might be wrong?!
Regards!
Rod answers this question on his forum here:
http://www.instantboard.com/users/rode/viewtopic.php?t=41
Check it out.
George
http://www.instantboard.com/users/rode/viewtopic.php?t=41
Check it out.
George
- Status
- Not open for further replies.