I want to build a preamp that use opa2604 as main amplifier, and want to use a pair as output driver to increase the output capacity. Which mosfet is best to do it? The supply voltage is +- 18v.
Thanks
Thanks
Thanks reply, Pass.
I mean use a couple of mosfet in the preamp output stage. The mosfet is biased and connect to opa2604 output pin directly. Mosfet output is RCA connector. Which mosfet is better, IRF510 and IRF9510 or a small JFET is enough?
Any advice is appreciated.
lazy
I mean use a couple of mosfet in the preamp output stage. The mosfet is biased and connect to opa2604 output pin directly. Mosfet output is RCA connector. Which mosfet is better, IRF510 and IRF9510 or a small JFET is enough?
Any advice is appreciated.
lazy
Zetex mosfet
Hey! I thought they were only good for building computers with. I wonder if the mosfets are fast enough to use inside the feedback loop of the OPA2604. This might be a little tricky for a beginner though.
H.H.
Hey! I thought they were only good for building computers with. I wonder if the mosfets are fast enough to use inside the feedback loop of the OPA2604. This might be a little tricky for a beginner though.
H.H.
- Status
- Not open for further replies.