Hi,
I want to change the OPs in my vintage Kenwood PreAmp .
Some Modifikations were discussed here years ago.
The goal is to place good sounding OPs with less DC-Offset at the outputs.
I guess i have to choose low input bias current types.
In the schematic Output there is a JRC 5532DD which causes 150mV Offset.
Is there OPA2132 / OPA 2134 a good choice ?
Or maybe a LM4562? The input current is higher, but about 20mV Offset would be acceptable.
The input buffers are JRC4580DD with 100mV Offset and a very low slew rate.
Maybe there are the LM4562 a good choice too ?
Jay
I want to change the OPs in my vintage Kenwood PreAmp .
Some Modifikations were discussed here years ago.
The goal is to place good sounding OPs with less DC-Offset at the outputs.
I guess i have to choose low input bias current types.
In the schematic Output there is a JRC 5532DD which causes 150mV Offset.
Is there OPA2132 / OPA 2134 a good choice ?
Or maybe a LM4562? The input current is higher, but about 20mV Offset would be acceptable.
The input buffers are JRC4580DD with 100mV Offset and a very low slew rate.
Maybe there are the LM4562 a good choice too ?
Jay
Attachments
The offset is not a problem in that design, and if anything I would say it defines a known and stable small voltage across the coupling caps.
The OPA's would generate near zero offset but as mentioned that isn't an issue anyway.
The LM4562 is possible replacement for the 5532 but I would advise that whatever you fit that you check any residual offset and reposition the coupling caps accordingly to suit any change in polarity of offset.
The OPA's would generate near zero offset but as mentioned that isn't an issue anyway.
The LM4562 is possible replacement for the 5532 but I would advise that whatever you fit that you check any residual offset and reposition the coupling caps accordingly to suit any change in polarity of offset.
I would advise that whatever you fit that you check any residual offset and reposition the coupling caps accordingly to suit any change in polarity of offset.
Do you think that at a 100mV polarity makes a difference? In what way?
I want to get rid of the coupling Cs ��
Yeah...Silly manufacturers are always putting extra parts in their products that don't need to be there.../s
Question: Why? Do you have a reason...or just a belief?
Mike
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- Source & Line
- Analog Line Level
- OP rolling