Just curious... has anybody tried using the One-Electron PRC-1 or PRC-2 "plate retard coils" as choke-input power supply chokes?
Seems like they would work well - they're designed for lots of AC voltage - and they're reasonably priced...
http://www.one-electron.com/trans.html
John, you out there?
Pete
Seems like they would work well - they're designed for lots of AC voltage - and they're reasonably priced...
http://www.one-electron.com/trans.html
John, you out there?
Pete
Pete,
I don' know the answer to your question, but Jack at Electra-Print wound a choke for a choke input PS (~30H for a 60mA DC PS) for me for a bit less than those cost. I don't have the receipt in front of me, but I think it was about 2/3 the cost. I have been abusing it at 75mA (w/ a small 1uF input cap to raise voltage a tad) without issue, noise, or ripple.
I don' know the answer to your question, but Jack at Electra-Print wound a choke for a choke input PS (~30H for a 60mA DC PS) for me for a bit less than those cost. I don't have the receipt in front of me, but I think it was about 2/3 the cost. I have been abusing it at 75mA (w/ a small 1uF input cap to raise voltage a tad) without issue, noise, or ripple.
- Status
- Not open for further replies.