• WARNING: Tube/Valve amplifiers use potentially LETHAL HIGH VOLTAGES.
    Building, troubleshooting and testing of these amplifiers should only be
    performed by someone who is thoroughly familiar with
    the safety precautions around high voltages.

Old Olympic audio tube amp

Status
Not open for further replies.
Based on the word "Stereo" on the front panel, I'm going to guess that there are 2 single ended channels using a 12AX7 section driver and a 50C5 "final".

The 50C5 data sheet suggests that the amp uses a series heater string and doesn't have a power transformer. That's both cheap and DANGEROUS.

Perhaps the best thing to do with that unit is canabalize the O/P "iron". Turning it into a safe guitar amp is probably not in the cards.
 
OK, I have good news... and more good news.

First, I'm holding the schematic in my hand - a scan will cost you an email...

Second, it actually has an isolation transformer in it (assuming it's the same as the SA-813 and 814...) so it's somewhat safe...

...and some bad news - you'll need another tube to get enough gain for a guitar - maybe add a 12AV6 or 12AU6?

tbavis(at)rochester(dot)rr(dot)com
 
Status
Not open for further replies.