I have done a lot of searching and I havent found anywhere that talks about going from looking at a schematic to designing the layout of your circuit board. Am I just being thick headed and really dont understand any of it, or is there some hope for me? lol
Anyways, Im looking at building a svt-cl. I have the schematics for the preamp and power amp, its just converting them to a layout i need help with. I would prefer to work point to point wiring, if that will make any design differences. Any advice will be greatly appreciated.🙂
Anyways, Im looking at building a svt-cl. I have the schematics for the preamp and power amp, its just converting them to a layout i need help with. I would prefer to work point to point wiring, if that will make any design differences. Any advice will be greatly appreciated.🙂
Check out the "Radiotron Designer's Handbook" from RCA, edited by Langford Smith. The fourth edition was published in 1953 and holds a wealth of information applicable to your needs.
- Status
- Not open for further replies.