You who have gotten them curved did they use a brake press or rolled?
They need to be around 10 -11 to get them rolled apparently. Will a brake press get a consistent curve?
They need to be around 10 -11 to get them rolled apparently. Will a brake press get a consistent curve?
perfmetal??
should form in a curve by placing them in a proper frame.
A brake press last time I looked was for cutting or bending sharply, not a gentle
curve for a curved ESL panel.
Maybe I am answering the wrong question...
_-_-
should form in a curve by placing them in a proper frame.
A brake press last time I looked was for cutting or bending sharply, not a gentle
curve for a curved ESL panel.
Maybe I am answering the wrong question...
_-_-
I just bend the rear stator in a frame. The front stator is them formed around the curve of the rear stator.
- Status
- Not open for further replies.