Found this waveguide browsing parts express. Anyone tried it yet? looks promising from the pictures, mostly conical with rounded mouth and throat
HornFlare Detail | Eminence Speaker
HornFlare Detail | Eminence Speaker
yes freuency and polars should be standard in the data sheets. someone should have already measured those in the construction. wouldnt be hard to just paste it in..
kinda like the seos, but narrower dispersion.
I like the round over in the mouth (horizontally).
$35 at partsexpress
Eminence WG10 1" High Frequency Waveguide 70x60 2-Bolt
1" compression driver for 70 x 60 dispersion
I like the round over in the mouth (horizontally).
$35 at partsexpress
Eminence WG10 1" High Frequency Waveguide 70x60 2-Bolt
1" compression driver for 70 x 60 dispersion
Last edited:
Yes, pity there's no polars or else it'd be worthy of consideration for a project I have coming up. Might just have to use the EWave WGs and get some decent screw on CDs instead.
And at the moment, $15 from Eminence. Shipping costs I don't know from either place. Pretty tempting! I wish there was a curve...don't even know what driver I'd put on it. That ubiquitious Selenium?
Peerless DFM 2544 is a good driver. Should work well on that waveguide.
DFM 2535 has good reviews as well.
DFM 2535 has good reviews as well.
Last edited:
Where is the good priced SEOS 12, Zvu?
The minimum xo of 1.4 kHz of the WG10 is a pitty. 1/λ is slightly higher than 1.3 kHz.
The minimum xo of 1.4 kHz of the WG10 is a pitty. 1/λ is slightly higher than 1.3 kHz.
Yes, I've asked Erich at diysoundgroup a couple times over the last 2 months if they ever get batches of any of the SEOS waveguides in stock. I haven't heard back yet. Too bad if they're gone for good. I'd really like to have tried some of the larger SEOS waveguides.
Dan
Dan