Hi all
I an electrical engineer and I have done a lot of audio, MC amps, preamps, power amps, all of my own design and development.
I have worked for Brüel and Kjær for seven years in a special acoustics group.
I hope to be able to help people in this field who have question I can answer.
I do also have a lot of PCB experience.
Regards
Vitreus
I an electrical engineer and I have done a lot of audio, MC amps, preamps, power amps, all of my own design and development.
I have worked for Brüel and Kjær for seven years in a special acoustics group.
I hope to be able to help people in this field who have question I can answer.
I do also have a lot of PCB experience.
Regards
Vitreus
Welcome!
I used a lot of B&K mikes professionally, and have always lusted after getting some to use personally. That must be a terrific job that you have.
I used a lot of B&K mikes professionally, and have always lusted after getting some to use personally. That must be a terrific job that you have.
Welcome to the forum... I have a friend who has a shrine to B&K ... a wall of fully functioning B&K measuring kit...beautiful stuff.
dave
dave
Hello
Welcome to the forum Vitreus.
I still have my B&K 4145 microphone capsules, but not anymore the 2801 power supply, at 200 volt of polarization voltage I do not know any diy power supply plans using modern op-amps to replace the 2801, do you know any ?
Bye
Gaetan
Welcome to the forum Vitreus.
I still have my B&K 4145 microphone capsules, but not anymore the 2801 power supply, at 200 volt of polarization voltage I do not know any diy power supply plans using modern op-amps to replace the 2801, do you know any ?
Bye
Gaetan
Last edited:
- Status
- Not open for further replies.