I received these cables today which I will include from now on to make it a little easier to connect.
An externally hosted image should be here but it was not working when we last tested it.
I received these cables today which I will include from now on to make it a little easier to connect.
An externally hosted image should be here but it was not working when we last tested it.
yes thats a good point.
How to bridge it?
Update, bad news ,it was all sounding soo great an all ...an then all went very quiet and there was a bad smell. Woops, I guess giving it just under 34v dc was too much for it after all. It was sounding sooo good too . damit.
i just ordered 3 more but i will keep my meanwell smps turned right down from now on!
Hi, I have ordered 36V DC SMPS for this board. Is it suitable or will I have to modify the board? Thanks...
the meanwell 36V smps can be turned down to 30-31VDC, so maybe also yours can.
I'm still trying to decide on a board to use for an upcoming multichannel amp project. Currently looking at 4 x 41hz amp9-b, 4 x sure 4*100, 8 x this TK2050 amp, or build my own TK2050 amp (sounds scary and like a fun challenge at the same time).
Questions:
Thanks!
- What considerations are there when powering multiple boards? Can a single power supply be split to multiple boards, and how would you wire it?
- How does this board handle DC offset? There is an application example in the Tripath 6ch TK2050 dev board using an opamp to correct for DC offset, but I didn't know if this had an automatic correction like that, or a manual correction like the sure boards, or no correction.
- How accessible are the mute and ovrldb pins on the TC2000? I'd want to tap into the mute pin to mute it, and the ovrldb pin to show an overload indicator.
- What value and type is the right angle pcb mounted volume pot? I'd probably get some front panel mounted pots to use instead and pull the existing one.
no. AC range is 16V - 24V. You can get it up to 26V if you change one resistor, R36.