I just ran across this website: www.emachineshop.com
It looks like a potential source for getting a project enclosure made to your own requirements. I haven't tried it yet but cursory examination looks promising. Expense is another mater. If you want something nicer than a Bud or Hammond box but don't have the equipment (or skills) to build your own this might fill the bill. It is probably not cheap but may well be cheaper than your local shop.
If anyone has tried these guys, a posting of your experience would be helpful
It looks like a potential source for getting a project enclosure made to your own requirements. I haven't tried it yet but cursory examination looks promising. Expense is another mater. If you want something nicer than a Bud or Hammond box but don't have the equipment (or skills) to build your own this might fill the bill. It is probably not cheap but may well be cheaper than your local shop.
If anyone has tried these guys, a posting of your experience would be helpful
ACD said:It looks very interesting. I must check it out
Yeah, looks like they're taking the same approach as ExpressPCB.
se
- Status
- Not open for further replies.